____________________ > Ava
> Used u. s. industrial model US625 hydraulic shear
Used u. s. industrial model US625 hydraulic shear
U. S. INDUSTRIAL HYDRAULIC SHEAR, MODEL US625
SERIAL NUMBER: J2004-172, SOLD NEW IN JANUARY OF 2005
1/4" X 6' CUTTING CAPACITY IN MILD STEEL
MACHINE HAS BEEN REFIRBISHED WITH NEW PARTS, CLEANED AND PAINTED AND COMES WITH 6 MONTH PARTS WARRANTY.
STANDARD EQUIPMENT: (All below comes with the machine)
Bolt on table segments qty of 2
High Carbon, High Chrome Shear Blades Hold-downs faced w/anti-mar neoprene
1 ball transfers Swing Beam Design
Manual Quick Change Blade gap adj. Pressure Sensing Hold downs
Squaring Arm, 43.5 from blade to end Electric stroke adjustment
Stroke Counter Operator control console
Front-controlled power back gauge Shadow lighting
Blade Guard, Micro switch protected Low noise gear pump
Hydraulic, Electrical Overload Protection Two Support arms
Automatic Swing-up on back gauge
* Includes 44 squaring arm, two support arms and material drop/support chute !!
* Machine can be wired for 208/220/230/240 OR 440/460/480 Volts, 3 Phase....your choice.
Shearing Capacity 1/4 Mild Steel @ 65000 PSI
Adjustment Range Of Back Gauge 0.75 -36
Dimensions (L x W x H) 8 x 5 x 5
* Look at the pic of the CLEAN electrical cabinent
* Look at machine pics, machine has been repaired, cleaned painted and returned to like new condition
Look at the pics....There is a pic of the entire machine from the left/front with the operators console on the left side. This console allows the operator to decide the cut depth by setting the power backgauge and looking at the readout. Also there is key protection so that only authorized operator can run machine. There is adjustment to allow only enough stroke to cut required width. Also, in pic from right side, you can see quick blade gap adjustment to allow operator to cut anywhere from 1/4" thick to very small gauge. There is also a pic of the material drop/support chute and the electrical cabinent. Also, I have included FOUR brochure pages from the factory.
Read my Lips....(Sorry, George, Sr.)
This machine is not on a skid, and CAN NOT be handle with forks. It has to be rigged with chains from the lifting lugs located at the top of each end frame. It weighs 11000 lbs. I would rather you pick it up with your flatbed truck or a double axle trailer. You should bring some tarps, cause you DON'T want it to get wet in the rain. We will load at no extra charge. For you folks who want to send a commercial truck, MAKE SURE you send a flat bed. Don't send a box trailer, because there is no good way to strap or chain down this machine inside a box trailer. You should send an "air-ride" flat bed truck, WITH TARPS. If you call them for a rate, tell them 11000 lbs., 8' of bed space coming from Memphis, Tennessee to your destination. I WILL QUOTE FREIGHT TO YOUR DESTINATION IF YOU WANT. Send me a question.
Machines must be removed from our facility within 14 days of sale. We reserve the right to charge storage fees after 14 days.
