____________________ > Ava
> System components
> Old Style
> Hydrolic Components
> 3 auger lubricant electronic dospenser ats electro-lube
3 auger lubricant electronic dospenser ats electro-lube
3 Auger Lubricant Electronic Dospenser ATS Electro-Lube
The Electro-Luber MD 2000 is a self-contained, microprocessor controlled, motor-driven automatic lubricator. Electro-Luber is an electronic dispenser lubricant providing continuous lubrication protection 24 hours a day. It may be called as a pressure vessel, it is not operated by gas production. In contrast, lubricator operation is dependent on the use of lower internal pressure forcing lubricant on the threads of a single screw pump rotating. This is what is mixed and distributes the lubricant at pressures up to 200 psi. takes the pressure lubricator to be used not only with long supply line pipes, and may even cycle progressive distributors allowing a MD 2000 to feed several bearings. When one or a combination of switches are turned on, the unit is activated at intervals selected. At each interval, approximately 1 cc of fat will be delivered to the bearing. Furthermore it is noted that oil production is not affected by outside temperature or altitude.
Advantages of using Electro Luber:
The benefits of the Electro Luber can be enumerated as follows -
1.This is a two-way method to automatically dispense the lubricant and grease from ball bearings. Therefore, promotes reusable motor driven units and the electrochemical cell that generates inert nitrogen gas.
2.The variety of Electro Lube on the market also takes advantage of high demand. Is available is of 125cc (8 3 / 4 "H x 3 1 / 6" diameter), 250cc (8 1 / 2 "H x 4" diameter), and 500 cc (8 1 / 2 "of H x 4 3 / 4 "diameter) sizes.
3.The lubricator is available in both alkaline and lithium battery packs and is designed as a single point lubricators to feed the ball bearings using multiple blocks Digilube progressive distribution.
5.Electro-Luber MD units can be used under water at depths of 60 feet (20 meters) and the use of alkaline batteries is recommended only up to 50 - 85 F (-10 - 30 C)
It is recommended that for successful implementation and reliable lubricator should avoid the use of Electro Luber automatic dispensers where fat at temperatures below 14 F (10 degrees C) above 170 F (76 C) or in an application requiring more than 200 psi. Installing the Electro Luber MD (units have 1 / 2 "NPT and come with a metal adapter) directly on the bearing is the best way to install the lubricator. Even after the filling is empty recharge can be done easily by using a standard gun.
