____________________   >   Auburn   >   System components   >   New Style   >   Tools   >   Hand tools   >   Semirigid assemby kit k/2.9/3.5/sma .085 .141 semirigid

Semirigid assemby kit k/2.9/3.5/sma .085 .141 semirigid


NEAR NEW Omni-Spectra Semi-Rigid Connector Assemby Kit
For 0.085 and 0.141 Semi-Rigid cable.
***Revision 4/25/2010: PLUS 2 EXTRA Deburring and Dielectric Trimming Tools.
One for 0.141 SemiRigid and the other for 0.085 (up to 0.089) SemiRigid.
These both have a removable hardened & machined cutting tool (4 cutting heads) inside of the outer shell housing.
The outer shell is a alignment guide only.
Only one tool is shown leaning against the front of the case in the photo.
The second tool was found after the photo was taken and isn't in the photograph.
PN's NEFE 6038-42-01 and NEFE6012-42-00.
I couldn't find these Deburring tools on the internet, but other similar ones cost $195 each!!!
This group is a bargain. It would cost well over $1,000 if you bought them new.
Can be used for 2.9mm / 3.5mm / SMA compatible connectors
The kit I'm selling is the complete kit, plus extra deburring/trimming tools.
Compare contents to picture at this website (not all slots have tools).
http:// /catalog/specsheets/2098Tyco.pdf
There are no instructions from the manufacturer for using this kit and it takes some thinking to figure how the tools are utilized.
My kit has Wiltron K Connector SemiRigid installation phamplet, that will help the user figure out the steps. Note that Wiltron/Anritsu actually uses 0.118 semi-rigid. I'm not sure if this kit would handle that diameter S/R.
Here is another Anritsu K/2.9mm connector installation instruction pamplet:
http://www.eu.anritsu.com/files/10200-00017.pdf
Also, see my other listings for 2.4mm and 2.9mm connectors, which use 0.085 semirigid.
Also, see my listings for Wiltron K120-x (2"/6"/12") lengths of Semi-Rigid that were assembled by Wiltron.
Also, see my listing for a Wiltron 0.118 cable assembly kit, with several each of male connectors, female connectors and semirigid.
* Condition: Nearly New Old Stock only used for a couple connectors.
* Cosmetics: Near Perfect - a few nicks on the outside of the box.



Semirigid assemby kit k/2.9/3.5/sma .085 .141 semirigid