____________________ > Albion
> System components
> Old Style
> Motor Components
> Gasoline Motor Component
> JD2 model 32 hydraulic tube pipe bender w/ cylinder
JD2 model 32 hydraulic tube pipe bender w/ cylinder
Includes the Model 32 Hydraulic Bender w/ degree ring and cylinder. Die sets, hydraulic pump, and pedestal sold separately. The Model 32 tube and pipe bender is the latest design by JD Squared. Essentially a super heavy duty version of the original Model 3, this machine makes bending extremely heavy wall material possible. The JD2 Model 32 can bend from 1/2" to 2" x .120" wall tubing manually with little effort because of the compound leverage from the ratcheting arm and can be upgraded to hydraulic power at any time. With hydraulics the machine is capable of bending up to 2.5" OD material, including 2" .250" wall DOM. (For manual operation the Model 32 must be solidly attached to a fixture such as our Floor Pedestal). The Model 32 bender is CNC machined from high strength cold rolled steel and holds up to daily use much better than look-alike benders. The die sets are equipped with replaceable alloy blocks which eliminate galling of steel tubing.
Standard on every Model 32 is the die locking mechanism. As the die rotates while bending the drive holes in the forming die pass under the lock pin. When the drive hole is below the lock pin, it drops into the drive hole and when pressure is removed from the bender the die's rotation is locked at that position. When bending resumes the ramp machined into the lock pin will automatically lift the pin out of the drive hole. This mechanism combined with the included anti-springback ratchet allows the Model 32 to better bend thin wall tubing as well as the heavier sizes of tubing such as 2" o.d. x .250" wall DOM tubing.The Model 32 excellent bend quality is guaranteed to be as good or better than any bender on the market in the $3,000 and under range. Die sets sold separately.
* 2.5" OD, 2" x .250" wall DOM, and 1.5" solid capacity
* 2" x .120" and 1" solid capacity with manual ratchet
Anti-Springback mechanism standard
* 3/4" thick frame links, 1/2" thick drive links
Model 32 Die Sets: Listed below are our most popular Model 3 Bender die sets. If you do not see the die set that you require, such as a different radius or Delrin followers for aluminum or stainless, please contact our sales staff for a recommendation or quote. All dies will bend up to a full U-bend of 180 . Min. Wall denotes the minimum recommended wall thickness for consistent high quality wrinkle free bends at the radius specified. CLR stands for "Center Line Radius", meaning the bend radius as measured from the center rotation point of the die to the middle of the tubing. Materials such as chrome moly or stainless may require special consideration.
