____________________ > Albion
> System components
> Old Style
> Hydrolic Components
> Low presure Components
> Snap on set tap and die metric 41 pieces 3MM to 12MM
Snap on set tap and die metric 41 pieces 3MM to 12MM
Snap On Set Tap and Die Metric 41 pieces 3mm to 12mm
Taps and dies from 3 to 12mm, a BSP tap and die, two die stocks, three tap wrenches, a metric thread pitch gauge, and a die adjusting screwdriver (41 pcs). Set includes T305M thru T1217M Metric Taps; D305M thru D1217M Metric Dies; T110M BSP Tap; D020M BSP Die; TD3A and TD10A Die Stocks; TD4A, TD50 and TD88A Tap Wrenches; TDM100 Metric Thread Pitch Gauge; and TDS1 Die Adjusting Screwdriver (41 pcs.) in storage case.
An important feature of the dies in these sets (except GAM541 and GAM540) is a small adjusting screw which changes the nominal size .003" under or over to give a tight or loose fit to your thread. Die size 1/4" to 1/2" and 7 mm to 12 mm are a one-piece, 12-point design that can be turned with a 1" socket wrench (5/8" socket wrench for 3 to 6 mm dies) when working in places where a normal die stock cannot be used. The three largest die stocks (TD10A, TD35, and TD40) are self-centering and adjust to the diameter of the bolt. U.S. Fed. Spec. GGG-T-60 applies to taps; GGG-D-296B applies to dies.
Set, Tap and Die, Metric, 41 pcs. (3mm to 12mm, Adjustable dies)
Metric Tap and Die Set (41 pcs.)
