____________________ > Albion
> Electronic components
> 8"x 18" lathe/mill instruction & parts manual
8"x 18" lathe/mill instruction & parts manual
This is a reproduction, not a photocopy, of an original Asian 8"x18" Bench Lathe/Mill Instructions and Parts Manual. This machine is manufactured in Asia and has been sold under many different names including: JET, Grizzly, Enco, MSC, etc... This manual contains information on lubrication, adjustments, maintenance, and controls as well as a complete parts list with exploded view diagrams.
with push and pull knob O.OO2"/O.OO47" (0.05/
CHAPTER I - RECEIVING.......................................................
CHAPTER II - ASSEMBLIES...................................................
CHAPTER III - ACCESSORIES...............................................
Collet Tie-Down Tube Handle.....................................................
Drill Chuck.................................................................................
Arbor.........................................................................................
Live Center.................................................................................
Rests..........................................................................................
The Thread Dial Indicator............................................................
Chuck Plate................................................................................
Change Gear...............................................................................
The Square Tool Post.................................................................
Tool Box....................................................................................
The Milling Unit...........................................................................
CHAPTER IV - LUBRICATION..............................................
CHAPTER V - ADJUSTMENTS..............................................
Adjusting the Headstock Spindle Bearings...................................
Adjusting the Slides.....................................................................
Adjustment of Peed Screw End Float..........................................
Adjusting the Peed Screw Backlash.............................................
Adjusting the Half-Nut Guide......................................................
Adjusting Lead Screw Backlash..................................................
Adjusting the Backlash of the Milling Head Feed Screw...............
Changing the Timing Belt.............................................................
Checking of Correct Tension of the Timing Belt...........................
CHAPTER VI - ELECTRICAL DIAGRAMS............................
CHAPTER VII - PARTS DIAGRAMS......................................
