____________________ > Auburn
> Electronic components
> Assortment of e-z lok thread inserts-19 pcs - jesco
Assortment of e-z lok thread inserts-19 pcs - jesco
4- #329-7 INTERNAL THREAD 7/16-14, TAP SIZE 5/8-11, DRILL BIT SIZE 17/32
5 - #329-9 INTERNAL THREAD 9/16-12, TAP SIZE 3/4-10, DRILL BIT SIZE 21/32
5 - #329-10 INTERNAL THREAD 5/8-11, TAP SIZE 7/8-9, DRILL BIT SIZE 49/64
5 - #329-12 INTERNAL THREAD 3/4-10, TAP SIZE 1-8, DRILL BIT SIZE 7/8
FACTORY WEB SITE: http:// /InsertsMetal/index.html
Q: What s the difference between E-Z LOK and coil threaded inserts?
A: There are two primary differences: design and installation.
As the name implies, coil inserts are steel wire coiled in a spring-like design. E-Z LOK threaded inserts are screw machined out of solid steel.
To install a coil insert, the user must have a special drill, special tap, and special installation tool. If a tap breaks or the installation tool is misplaced, the coil inserts can t be installed until a new tap or installation tool is purchased. E-Z LOK threaded inserts have standard size/pitch threads so they can be installed using standard tools you probably already have in your toolbox. For example, if an E-Z LOK with a 1/2-13 external thread is being installed, the user simply drills the hole with a standard 27/64 drill and then taps the hole with a standard 1/2-13 tap. Once that s done, the insert is threaded into the hole like an ordinary fastener using a screwdriver, bolt and jam nut, or an E-Z LOK drive tool.
Unlike coil inserts, which require a special drill, tap, and installation tool, E-Z LOK threaded inserts for metal are installed using standard tools. Simply drill the appropriately sized hole with a standard drill tap the hole with a standard tap and then turn in the E-Z LOK like an ordinary fastener with a screwdriver, bolt and jam nut, or an E-Z LOK drive tool. Installation is as easy as 1-2-3.
Drill hole with standard drill.
E-Z LOK inserts are self-locking. Immediately upon installation, pre-applied Loctite on the external threads begins to set and the newly installed insert is fastener ready in minutes. At full cure (72 hours), the Loctite seals against liquids and gases to pressures of 6,000 psi.
Easy Removal: E-Z LOK threaded inserts can be removed with a bolt extractor or by heating the inserts to over 300*F.
Turn insert home flush with screwdriver, bolt and jam nut, or E-Z LOK drive tool